Corrective Surgery Using Virtual Surgical Simulation and a Three-Dimensional Printed Osteotomy Guide: A Case Report / 대한족부족관절학회지

A 74-year-old female patient, who underwent surgery for a left distal tibiofibular fracture 40 years earlier, visited the hospital with an ankle varus deformity due to malunion. The patient complained of discomfort while walking due to the ankle and hindfoot varus deformity but did not complain of ankle pain. Therefore, correction using supramalleolar osteotomy was planned, and through virtual surgical simulation, it was predicted that a correction angle of 24° and an osteotomy gap open of 12 mm would be necessary. An osteotomy guide and an osteotomy gap block were made using three-dimensional (3D) printing to perform the osteotomy and correct the deformity according to the predicted goal. One year after surgery, it was observed that the ankle varus was corrected according to the surgical simulation, and the patient was able to walk comfortably. Thus, for correction of deformity, virtual surgical simulation and a 3D-printed osteotomy guide can be used to predict the target value for correction. This is useful for increasing the accuracy of correction of the deformity.

Which Approach Is Most Optimal for Needle Electromyographic Examination of the Biceps Femoris Short Head: Medial or Lateral?

Objective@#To investigate the anatomical characteristics of the biceps femoris short head (BS) and determine the optimal needle placement for BS examination. @*Methods@#Twenty-one lower limbs were dissected. The distances from the medial and lateral margins of the biceps femoris long head (BL) tendon to the common fibular nerve (CFN) (M_CFN_VD and L_CFN_VD, respectively) and the distance from the lateral margin of the BL tendon to the lateral margin of the BS (L_BS_HD) were measured 5 cm proximal to the tip of the fibular head (P1), four fingerbreadths proximal to the tip of the fibular head (P2), and at the upper apex of the popliteal fossa (P3). @*Results@#The BS was located lateral to the BL tendon. The CFN was located along the medial margin of the BL tendon. The median values were 2.0 (P1), 3.0 (P2), and 0 mm (P3) for M_CFN_VD; and 17.4 (P1), 20.2 (P2), and 21.8 mm (P3) for L_CFN_VD; and 8.1 (P1), 8.8 (P2), and 13.0 mm (P3) for L_BS_VD. @*Conclusion@#The lateral approach to the BL tendon was safer than the medial approach for examining the BS. Amore proximal insertion site around the upper apex of the popliteal fossa was more accurate than the distal insertion site. In this study, we propose a safer and more accurate approach for electromyography of the BS.